Williamson County area
Commercial Fitness Equipment in Franklin
- 2007designing and equipping fitness facilities since
- 30,000+commercial orders delivered
- 500+cities served
- 50+manufacturer partners
Installed by Fit Supply
Apartment Fitness Projects in Franklin, Start to Finish
Our documented Franklin project is a clubhouse fitness room in an established community — a long rectangular space under a tray ceiling with cove lighting, its floor laid in black rubber, holding two banks of cardio and a selectorized strength line along the far wall. It reads as a refresh of a working room rather than a new build, which is the more common job in a market this mature. See it on our Tennessee work page.
Franklin work concentrates in apartment and condominium communities. In a room that stays open while it is being re-equipped, the sequence matters as much as the specification — what comes out, what goes back, and what the residents can still use in between.
Design and equipment specification for a Franklin project are handled directly by Fit Supply, with delivery and installation coordinated through our nationwide installation-partner network rather than a travelling crew.
Franklin sits in Williamson County beside Brentwood, Spring Hill and Nashville, so a portfolio across the southern metro is handled as one project rather than several.
The scope available in Franklin covers equipment consultation, layout and design, procurement, flooring and mirrors, delivery and installation, finance options and extended warranties. On-site service and preventive maintenance are performed directly by Fit Supply in Texas and Arizona only; in Tennessee they run through our service-partner network.
Working in Franklin
Most of our work in Franklin is apartment and condominium communities.
What we equip in Franklin
The category below is the one Franklin works in most, ranked by the volume we have actually supplied there. Each asks something different of the floor, the power and the clearances, so each is planned from the room outward.
Apartment and condominium amenity rooms
Electrical is the item that most often turns a finished amenity room into a second construction project, because the space was never wired for it. Commercial treadmills need a dedicated 120V, 20-amp branch circuit each, with a non-looped neutral and ground — three treadmills is three circuits, not one shared run. Doors are the companion trap: ADA sets a 32 in minimum clear opening measured with the door open 90 degrees, and a nominal 3 ft leaf does not deliver it once the stop and hardware are counted. Both are cheap to solve while the walls are open and disruptive afterwards, so we raise them during design. More on apartment and condominium amenity rooms.
Service, Repairs and Preventive Maintenance in Franklin
Fit Supply coordinates equipment service, repairs, and preventive maintenance nationwide through our network of service and installation partners, rather than a Fit Supply crew.
Coverage in Franklin
Franklin is part of our nationwide service network, alongside Brentwood and Spring Hill. A local service partner handles repairs, warranty work and preventive maintenance visits to the same standard Fit Supply sets for the work our own crews perform directly in Texas and Arizona.
Preventive maintenance plans
Preventive maintenance is offered in three tiers — Silver, Gold and Platinum — see the full PM tier structure. Every repair and PM visit is quoted and approved before work begins.
In short
Commercial gym equipment, facility design and installation in Franklin, TN, from Fit Supply. Coverage runs across the Williamson County area to Brentwood, Spring Hill and Nashville. Layouts hold the ADA clear floor space of 30 by 48 in for at least one of each type of machine. Most of our Franklin work is in apartment and condominium communities.
Common questions about Franklin projects
Can a fitness room go on an upper floor of an apartment building?
Often, but it is a structural question first. IBC Table 1607.1 designs fitness areas for a 100 psf live load and residential areas outside sleeping rooms for 40 psf, so converting residential space is a change of use. Your structural engineer confirms what the existing framing carries; we plan the layout around that answer, including where the heaviest racks and plate storage sit.
Do we need a structural check before adding weights in Tennessee?
For a ground-floor slab, rarely. Above grade, it is the sensible order of operations: IBC table 1607.1 asks 100 psf of a gymnasium and 40 psf of a residential floor, and free weights concentrate load rather than spreading it. We lay the heavy equipment out against whatever the structural drawings allow, so the plan reflects the building instead of the building having to absorb the plan.
Do you cover properties near Franklin?
Yes. Franklin sits inside our coverage in Williamson County, and the same crews work Brentwood, Spring Hill and Nashville. For an operator running more than one property across those markets, that means one specification, one point of contact and one parts channel rather than a separate arrangement per site.
What are your payment terms?
Terms vary from deal to deal and are set out in your proposal. What does not vary: a 50% deposit is required on all orders before equipment is ordered. Finance options are available and are quoted alongside the equipment.
Do you sell used gym equipment?
Yes. Fit Supply sells used and pre-owned commercial fitness equipment at a discount alongside new. Properly reconditioned commercial equipment will typically outlast new light-commercial equipment at a similar price, and it lets a build-out budget cover more of the floor. Ask what is available when you request a quote — inventory moves.